•The origin of benzene under hydrothermal conditions was investigated.•Benzene production from cyclic compounds was observed at 300 °C and 85 bar.•Benzene formation was enhanced in the presence of different powdered minerals.•Sulfides and iron oxide minerals enhance reactivity especially of CH bonds.•Benzene from dehydrogenation of cyclics highly depends on the presence of minerals.Volatile Organic Compounds (VOCs) are ubiquitously present at low but detectable concentrations in hydrothermal fluids from volcanic and geothermal systems. Although their behavior is strictly controlled by physical and chemical parameters, the mechanisms responsible for the production of most VOCs in natural environments are poorly understood. Among them, benzene, whose abundances were found to be relatively high in hydrothermal gases, can theoretically be originated from reversible catalytic reforming processes, i.e. multi-step dehydrogenation reactions, involving saturated hydrocarbons. However, this hypothesis and other hypotheses are difficult to definitively prove on the basis of compositional data obtained by natural gas discharges only. In this study, therefore, laboratory experiments were carried out to investigate the production of benzene from cyclic hydrocarbons at hydrothermal conditions, specifically 300 °C and 85 bar. The results of experiments carried out in the presence of water and selected powdered minerals, suggest that cyclohexane undergoes dehydrogenation to form benzene, with cyclohexene and cyclohexadiene as by-products, and also as likely reaction intermediates. This reaction is slow when carried out in water alone and competes with isomerization and hydration pathways. However, benzene formation was increased compared to these competing reactions in the presence of sulfide (sphalerite and pyrite) and iron oxide (magnetite and hematite) minerals, whereas no enhancement of any reaction products was observed in the presence of quartz. The production of thiols was observed in experiments involving sphalerite and pyrite, suggesting that sulfide minerals may act both to enhance reactivity and also as reactants after dissolution. These experiments demonstrate that benzene can be effectively produced at hydrothermal conditions through dehydrogenation of saturated cyclic organic structures and highlight the crucial role played by minerals in this process.

Oxidations of phenylacetic acid to benzaldehyde, benzyl alcohol to benzaldehyde, and benzaldehyde to benzoic acid have been observed, in water as the solvent and using only copper(II) chloride as the oxidant. The reactions are performed at 250 °C and 40 bar, conditions that mimic hydrothermal reactions that are geochemically relevant. Speciation calculations show that the oxidizing agent is not freely solvated copper(II) ions, but complexes of copper(II) with chloride and carboxylate anions. Measurements of the reaction stoichiometries and also of substituent effects on reactivity allow plausible mechanisms to be proposed. These oxidation reactions are relevant to green chemistry in that they proceed in high chemical yield in water as the solvent and avoid the use of toxic heavy metal oxidizing reagents.

Sequestering carbon dioxide emissions by the trap and release of CO2 via thermally activated chemical reactions has proven problematic because of the energetic requirements of the release reactions. Here we demonstrate trap and release of carbon dioxide using electrochemical activation, where the reactions in both directions are exergonic and proceed rapidly with low activation barriers. One-electron reduction of 4,4′-bipyridine forms the radical anion, which undergoes rapid covalent bond formation with carbon dioxide to form an adduct. One-electron oxidation of this adduct releases the bipyridine and carbon dioxide. Reversible trap and release of carbon dioxide over multiple cycles is demonstrated in solution at room temperature, and without the requirement for thermal activation.

Hydrothermal organic transformations under geochemically relevant conditions can result in complex product mixtures that form via multiple reaction pathways. The hydrothermal decomposition reactions of the model ketone dibenzyl ketone form a mixture of reduction, dehydration, fragmentation, and coupling products that suggest simultaneous and competitive radical and ionic reaction pathways. Here we show how Norrish Type I photocleavage of dibenzyl ketone can be used to independently generate the benzyl radicals previously proposed as the primary intermediates for the pure hydrothermal reaction. Under hydrothermal conditions, the benzyl radicals undergo hydrogen atom abstraction from dibenzyl ketone and para-coupling reactions that are not observed under ambient conditions. The photochemical method allows the primary radical coupling products to be identified, and because these products are generated rapidly, the method also allows the kinetics of the subsequent dehydration and Paal–Knorr cyclization reactions to be measured. In this way, the radical and ionic thermal and hydrothermal reaction pathways can be studied separately.