Co-reporter:Adam R. Vaughan;James D. Lee;Marvin D. Shaw;Pawel K. Misztal;Stefan Metzger;Massimo Vieno;Brian Davison;Thomas G. Karl;Lucy J. Carpenter;Alastair C. Lewis;Ruth M. Purvis;Allen H. Goldstein;C. Nicholas Hewitt
Faraday Discussions 2017 (Volume 200) pp:599-620
Publication Date(Web):2017/08/22
DOI:10.1039/C7FD00002B
Volatile organic compounds (VOCs) originate from a variety of sources, and play an intrinsic role in influencing air quality. Some VOCs, including benzene, are carcinogens and so directly affect human health, while others, such as isoprene, are very reactive in the atmosphere and play an important role in the formation of secondary pollutants such as ozone and particles. Here we report spatially-resolved measurements of the surface-to-atmosphere fluxes of VOCs across London and SE England made in 2013 and 2014. High-frequency 3-D wind velocities and VOC volume mixing ratios (made by proton transfer reaction – mass spectrometry) were obtained from a low-flying aircraft and used to calculate fluxes using the technique of eddy covariance. A footprint model was then used to quantify the flux contribution from the ground surface at spatial resolution of 100 m, averaged to 1 km. Measured fluxes of benzene over Greater London showed positive agreement with the UK’s National Atmospheric Emissions Inventory, with the highest fluxes originating from central London. Comparison of MTBE and toluene fluxes suggest that petroleum evaporation is an important emission source of toluene in central London. Outside London, increased isoprene emissions were observed over wooded areas, at rates greater than those predicted by a UK regional application of the European Monitoring and Evaluation Programme model (EMEP4UK). This work demonstrates the applicability of the airborne eddy covariance method to the determination of anthropogenic and biogenic VOC fluxes and the possibility of validating emission inventories through measurements.
Co-reporter:James D. Lee, Carole Helfter, Ruth M. Purvis, Sean D. Beevers, David C. Carslaw, Alastair C. Lewis, Sarah J. Møller, Anja Tremper, Adam Vaughan, and Eiko G. Nemitz
Environmental Science & Technology 2015 Volume 49(Issue 2) pp:1025
Publication Date(Web):December 12, 2014
DOI:10.1021/es5049072
Direct measurements of NOx concentration and flux were made from a tall tower in central London, UK as part of the Clean Air for London (ClearfLo) project. Fast time resolution (10 Hz) NO and NO2 concentrations were measured and combined with fast vertical wind measurements to provide top-down flux estimates using the eddy covariance technique. Measured NOx fluxes were usually positive and ranged from close to zero at night to 2000–8000 ng m–2 s–1 during the day. Peak fluxes were usually observed in the morning, coincident with the maximum traffic flow. Measurements of the NOx flux have been scaled and compared to the UK National Atmospheric Emissions Inventory (NAEI) estimate of NOx emission for the measurement footprint. The measurements are on average 80% higher than the NAEI emission inventory for all of London. Observations made in westerly airflow (from parts of London where traffic is a smaller fraction of the NOx source) showed a better agreement on average with the inventory. The observations suggest that the emissions inventory is poorest at estimating NOx when traffic is the dominant source, in this case from an easterly direction from the BT Tower. Agreement between the measurements and the London Atmospheric Emissions Inventory (LAEI) are better, due to the more explicit treatment of traffic flow by this more detailed inventory. The flux observations support previous tailpipe observations of higher NOx emitted from the London vehicle diesel fleet than is represented in the NAEI or predicted for several EURO emission control technologies. Higher-than-anticipated vehicle NOx is likely responsible for the significant discrepancies that exist in London between observed NOx and long-term NOx projections.