D4020 resin offered the best dynamic adsorption and desorption capacity for total flavonoids based on the research results from ten kinds of macroporous resin. A column packed with D4020 resin was used to optimize the separation of total flavonoids from Flaveria bidentis (L.) Kuntze extracts. The content of flavonoids in the product was increased from 4.3 to 30.1% with a recovery yield of 90%. After the treatment with gradient elution on D4020 resin, the contents of isorhamnetin 3-sulfate and astragalin were increased from 0.49 to 8.70% with a recovery yield of 74.1% and 1.16 to 30.8%, with a recovery yield of 92.2%, respectively. Further purification was carried out by one-run high-speed countercurrent chromatography yielding 4.5 mg of isorhamnetin 3-sulfate at a high purity of 96.48% and yielding 24.4 mg of astragalin at a high purity of over 98.46%.

Magnetic particles with suitable surface modification are capable of binding proteins selectively, and magnetic separations have advantages of rapidity, convenience, and high selectivity. In this paper, new magnetic nanoparticles modified with imidazolium ionic liquid (Fe₃O₄@SiO₂@ILs) were successfully fabricated. N-Methylimidazolium was immobilized onto silica-coated magnetic nanoparticles via γ-chloropropyl modification as a magnetic nanoadsorbent for heme protein separation. The particle size was about 90 nm without significant aggregation during the preparation process. Hemoglobin as one of heme proteins used in this experiment was compared with other nonheme proteins. It has been found that the magnetic nanoparticles can be used for more rapid, efficient, and specific adsorption of hemoglobin with a binding capacity as high as 5.78 mg/mg. In comparison with other adsorption materials of proteins in the previous reports, Fe₃O₄@SiO₂@ILs magnetic nanoparticles exhibit the excellent performance in isolation of heme proteins with higher binding capacity and selectivity. In addition, a short separation time makes the functionalized nanoparticles suitable for purifying unstable proteins, as well as having other potential applications in a variety of biomedical fields.

Chlorogenic acid and caffeic acid were selected as test samples for separation by the pH-zone-refining countercurrent chromatography (CCC). The separation of these test samples was performed with a two-phase solvent system composed of methyl-tert-butyl-ether/acetonitrile/water at a volume ratio of 4:1:5 v/v/v where trifluoroacetic acid (TFA; 8 mM) was added to the organic stationary phase as a retainer and NH₄OH (10 mM) to the aqueous mobile phase as an eluter. Chlorogenic acid was successfully separated from Flaveria bidentis (L.) Kuntze (F. bidentis) and Lonicerae Flos by pH-zone-refining CCC, a slightly polar two-phase solvent system composed of methyl-tert-butyl-ether/acetonitrile/n-butanol/water at a volume ratio of 4:1:1:5 v/v/v/v was selected where TFA (3 mM) was added to the organic stationary phase as a retainer and NH₄OH (3 mM) to the aqueous mobile phase as an eluter. A 16.2 mg amount of chlorogenic acid with the purity of 92% from 1.4 g of F. bidentis, and 134 mg of chlorogenic acid at the purity of 99% from 1.3 g of crude extract of Lonicerae Flos have been obtained. These results suggest that pH-zone-refining CCC is suitable for the isolation of the chlorogenic acid from the crude extracts of F. bidentis and Lonicerae Flos.

In order to utilize and control the invasive weed, bioactive compounds from essential oil of Flaveria bidentis (L.) Kuntze were studied. Steam distillation extraction and one step high-speed counter-current chromatography were applied to separate and purify the caryophyllene oxide, 7,11-dimethyl-3-methylene-1,6,10-dodecatriene, and caryophyllene from essential oil of Flaveria bidentis (L.) Kuntze. The two-phase solvent system containing n-hexane/acetonitrile/ethanol (5:4:3, v/v/v) was selected for the one step separation mode according to the partition coefficient values (K) of the target compounds and the separation factor (α). The purity of each isolated fraction after a single high-speed counter-current chromatography run was determined by high performance liquid chromatography. A 3.2 mg of caryophyllene oxide at a purity of 92.6%, 10.4 mg of 7,11-dimethyl-3-methylene-1,6,10-dodecatriene at a purity of 99.1% and 5.7 mg of caryophyllene at a purity of 98.8% were obtained from 200 mg essential oil of Flaveria bidentis (L.) Kuntze. The chemical structures of these components were identified by GC-MS, ¹H-NMR, and ¹³C-NMR.

Semipreparative high-speed counter-current chromatography (HSCCC) by time-controlled collection method was successfully applied for isolation and purification of α-terthienyl, 5-(3-buten-1-ynyl)-2,2′-bithienyl, and 5-(3-penten-1-ynyl)-2,2′-bithienyl from Flaveria bidentis (L.) Kuntze for the first time. The two-phase solvent system composed of n-hexane and acetonitrile at the volume ratio of 1:1 (v/v) was used for the semipreparative HSCCC. The 5.2 mg α-terthienyl, 2.2 mg 5-(3-buten-1-ynyl)-2,2′-bithienyl, and 4.3 mg 5-(3-penten-1-ynyl)-2,2′-bithienyl with the purity of 99.9, 90.2, and 92.1% were produced from 265.6 mg crude extract, respectively, and 5-(3-penten-1-ynyl)-2,2′-bithienyl was first isolated from Flaveria bidentis (L.) Kuntze. The structures of the separated compounds were identified by electrospray-ionization mass spectrometry and proton and carbon nuclear magnetic resonance (¹H- and ¹³C-NMR).

The first preparative separation of a flavonoid sulphate isorhamnetin 3-sulphate from Flaveria bidentis (L.) Kuntze by counter-current chromatography (CCC) was presented. Two kinds of solvent systems were used. A conventional organic/aqueous solvent system n-butanol–ethyl acetate–water (4:1:5, v/v) was used, yielding isorhamnetin 3-sulphate 2.0 mg with a purity of 93.4% from 83 mg of pre-enriched crude extract obtained from 553 mg ethanol extract by macroporous resin. A one-component organic/salt-containing system composed of n-butanol–0.25% sodium chloride aqueous solution (1:1, v/v) was also used, and the LC column packed with macroporous resin has been employed for desalination of the target compound purified from CCC. As a result, 2.1 mg of isorhamnetin 3-sulphate with a purity of over 97% has been isolated from 402 mg of crude extract without pre-enrichment. Compared with the conventional organic/aqueous system, the one-component organic/salt-containing aqueous system was more suitable for the separation of isorhamnetin 3-sulphate, and purer target compound was obtained from the crude extract without pre-enrichment using the new solvent system. The chemical structure was confirmed by ESI-MS and ¹H, ¹³C NMR. In summary, our results indicated that CCC using one-component organic/salt-containing aqueous solution is very promising and powerful for high-throughput purification of isorhamnetin 3-sulphate from Flaveria bidentis (L.) Kuntze.

Three active compounds, senkyunolide-I, senkyunolide-H and ferulic acid (FA), were successfully isolated and purified from the extracts of Rhizoma Chuanxiong by counter-current chromatography (CCC). Based on the principle of the partition coefficient values (k) for target compounds and the separation factor (α) between target compounds, the two-phase solvent system that contains n-hexane–ethyl acetate–methanol–water at an optimized volume ratio of 3:7:4:6 v/v was selected for the CCC separation, and the lower phase was employed as the mobile phase in the head-to-tail elution mode. In a single run, 400 mg of the crude extract yielded pure senkyunolide-I (6.4 mg), senkyunolide-H (1.7 mg) and FA (4.4 mg) with the purities of 98, 93 and 99%, respectively. The CCC fractions were analyzed by high-performance liquid chromatography, and the structures of the three active compounds were identified by MS and ¹H NMR.